AMBER Archive (2005)

Subject: AMBER: Problems with Iodine

From: David.Maxwell_at_di.mdacc.tmc.edu
Date: Fri Mar 18 2005 - 15:03:38 CST


I am having difficulties running a sander minimization with a ligand
containing iodine. It seems to pass through leap okay, but when a run is
initiated, I get the following error, followed by the usual MPI related
information:

 bad atom type: i

If I go back and change it to a hydrogen, rerun the setup to create a new
.top and .crd, all is fine. A diff between the leap.log files doesn't
show any differences. I am using Antechamber for the construction of a
suitable .mol2 file for leap to read in.

I am running Version 8 of AMBER compiled with "make parallel" on an SGI
Tezro. It was also tested this on an Altix 350 under version 8 and it has
the same problem.

Any thoughts on what might be causing this? Thanks in advance for your
help.

-Dave

_____________________________________________
David Maxwell, Ph.D.
Senior Research Scientist
Dept. of Experimental Diagnostic Imaging
University of Texas M.D. Anderson Cancer Center
8012 El Rio St.
Houston, TX 77054
Phone: (713)-563-9963 Fax: (713)-563-0084
david.maxwell_at_di.mdacc.tmc.edu
-----------------------------------------------------------------------
The AMBER Mail Reflector
To post, send mail to amber_at_scripps.edu
To unsubscribe, send "unsubscribe amber" to majordomo_at_scripps.edu