AMBER Archive (2008)

Subject: Re: AMBER: AMBER 9 testing

From: Taufik Al-Sarraj (taufik.alsarraj_at_utoronto.ca)
Date: Fri Mar 28 2008 - 23:13:31 CDT

Thank you David,
I am not sure how to configure the serial version.
  if i type uname -m i get IP35
so i tried ./configure -IP35 sgi_mips
this does not work and i get the configure help output

I am using IRIX version 6.5 on an SGI Octane 2 machine

David A. Case wrote:
> On Fri, Mar 28, 2008, Taufik Al-Sarraj wrote:
>> i just installed AMBER 9 in an IRIX machine, i wanted to make sure i
>> installed the program correctly. I am using IRIX 6.5
>>
>> i used ./configure -mpi sgi_mips
>> and make parallel
>
> You also need to make the serial version.
>
>> i tried
>> make test.sander
>> don't know how to make test.sander (bu42)
>
> The primary commands are "make test.serial" and "make test.parallel".
>
>> make test.leap
>> cd leap; ./Run.tleap
>> Error: ./tleap --> ../../exe/teLeap does not exist
>
> This is probably because you did not make the serial codes.
>
> ...good luck....dac
>
> -----------------------------------------------------------------------
> The AMBER Mail Reflector
> To post, send mail to amber_at_scripps.edu
> To unsubscribe, send "unsubscribe amber" to majordomo_at_scripps.edu


-----------------------------------------------------------------------
The AMBER Mail Reflector
To post, send mail to amber_at_scripps.edu
To unsubscribe, send "unsubscribe amber" to majordomo_at_scripps.edu