AMBER Archive (2008)

Subject: Re: AMBER: Clarification on error message

From: Thomas Steinbrecher (steinbrt_at_scripps.edu)
Date: Sat Mar 08 2008 - 14:17:35 CST

Hi Patrick,

did you specify a reference coordinate file with the -ref switch in your
sander command? If yes, is that file present and readable to your process?
Did you set ntr=1 in your mdin file so that sander expects a reference
file?

Regards,

Thomas

Dr. Thomas Steinbrecher
The Scripps Research Institute
10550 N. Torrey Pines Rd.
San Diego CA 92037, USA

On Sat, 8 Mar 2008, Campbell, Patrick wrote:

> Good Morning AMBER Analysts,
>  
> I have an error in a minimization output file which I was hoping you would clarify.
>  
>  
> Unit   10 Error on OPEN: refc
>  
>  
> I have attached the output file for reference.
>  
> Thanks for your assistance and do have a great day!
>
> Patrick
>  
>  
>
-----------------------------------------------------------------------
The AMBER Mail Reflector
To post, send mail to amber_at_scripps.edu
To unsubscribe, send "unsubscribe amber" to majordomo_at_scripps.edu